Specially modified 65-66 battery tray uses 67-70 style holddown brackets and hardware for use with aftermarket batteries missing the holddown foot. Complete kit includes tray, holddown clamp, rods, rod nuts and tray mounting hardware.
Ford Mustang Years:
1965 (65), 1966 (66)
Above years shown are used for searches and are not application listings.
NPD Part Number : 10732-1CPK Manufacturer Reference #'s: 10732-1CPK,
1965-1966 MUSTANG GROUP 22, 24 BATTERY
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
This is a great setup for a '66 Mustang converting to a modern battery, this tray has a top bracket to hold down the battery. The original tray had a bottom bracket to hold the battery however modern batteries do not have a lip at the bottom of the battery for the bottom bracket to grab onto.
Submitted on May 12, 2022 by Chris S.
YES I would recommend this product.
Quality
Value
A great solution as some newer batteries don't have the hold-down ridge on the bottom. Definitely more secure than the stock 1965 battery tray.
Submitted on November 14, 2022 by Charles C.
YES I would recommend this product.
Quality
Value
Great solution. New batteries don't have a bump for the hold-down on the side. This tray is much more secure. It bolted right into my 65. Good solution
Submitted on November 16, 2022 by Charles C.
YES I would recommend this product.
Quality
Value
Quick delivery and great product.. I like the grab handle was insulated..
Submitted on May 20, 2023 by Michael W.
YES I would recommend this product.
Quality
Value
Submitted on September 29, 2023 by Tom D.
YES I would recommend this product.
Quality
Value
Seems well built holds the battery and the hold down does the trick! Bolt holes weren’t the same as the original but a dill/bit and all is good
Submitted on October 24, 2023 by Altus B.
YES I would recommend this product.
Quality
Value
Sturdy and well made. Its a great solution to replace the "lack of support" 24F battery with a more commonly available one. I needed to do some hammer work on the 65' apron (all under where the new box will sit) to clear the 67 style tray.
Submitted on November 05, 2023 by Dennis H.
YES I would recommend this product.
Quality
Value
The battery tray attachment points did not match the mounting points on the inner apron. I had to drill new holes in the apron to meet the tray mounts. So it’s not an exact direct replacement.
Submitted on November 15, 2023 by Ron D.
If
a car has a repro apron, many times people will drill it to fit the battery tray.
Unfortunately the battery trays vary a bit and can have the holes located
slightly off compared to an original. The only way to properly test fit
this and other battery trays would be to fit it to an original apron. Also, simply adjusting the lower brace can also improve fit. Given that it's impossible to know the "past" of most cars, and many rusty aprons have been replaced with unknown-manufacturer reproduction battery trays, there is always the possibility of variation when buying a new tray. This tray included with our 10732-1CPK kit is manufactured by the same factory that makes our standard/original 10732-1B tray, both of which we have sold thousands of without issue. Again, because of the dynamics involved, you never know what you're going to get into replacing a tray, EVEN IF you are installing an original Ford tray.
Quality
Value
In Stock!
